Calibration Traceability
 

Protrol are members of BSi Standards and Protrol Quality System is fully certified to BS EN ISO 9001:2015 by UKAS and ANAB accredited certification body ISOQAR. To further demonstrate our commitment to quality and traceability Protrol operate a Calibration and Standards Laboratory in full compliance with the requirements of BS EN ISO 10012:2003 and BS EN ISO 17025:2005 along with National and International Standards and procedures where required.

Calibration Cer​tificates
 

Certificates of Calibration are issued for all Instruments calibrated in our Laboratory All Test and Calibration information is entered onto Protrol Computer System Calibration Software and Re-calibration Data Base

 

If required our Technicians are available to carry out Calibration works at Clients premises( where possible ), thus reducing "downtime" to a minimum.

 

Advice is freely offered on all aspects of Calibration, Sales or Hire before and after products are supplied

 

 

Services and Instrument types

 

The Facilities offered by our Calibration and Standards Laboratory are available to our clients and offer a competitive and efficient calibration directly traceable to the National Physical Laboratory (NPL) for Instruments and Equipment in the following categories:

 

* ELECTRICAL & ELECTRONIC

* PRESSURE MEASUREMENT

* PHYSICAL & DIMENSIONAL  ( METROLOGY) 

* VACUUM MEASUREMENT

* TEMPERATUREMEASUREMENT

* LOW AIR FLOWMEASUREMENT
* FORCE, TENSION & COMPRESSION

* SPECIFIC GRAVITY, CONDUCTIVITY, PH VISCOSITY & HUMIDITY

* ANALYTICAL & GAS DETECTION & MEASUREMENT EQUIPMENT

* EQUIPMENT HIRE, SALES &  SERVICE

* PROCESS INSTRUMENT CALIBRATION

* TORQUE CALIBRATION

* MASS CALIBRATION