MicroBio MB2-HiFlow Bioaerosol Sampler


Sampling at 180 litres per minute

Bioaerosol samplers are vital equipment for use in bioaerosol research, clean rooms, pharmaceutical validation, food production and packaging, indoor air quality, HVAC and throughout hospitals and healthcare settings, wherever air hygiene is vital. The MicroBio MB2-HiFlow Bioaerosol Sampler has all the features of the tried and trusted MicroBio MB2 model, but with the added advantage of sampling at a rate of 180 litres per minute, nearly halving the time to take a sample. The time to sample a cubic meter of air is reduced from 10 minutes to 6 minutes.


Trusted economical sampling

The MicroBio MB2-HiFlow uses standard 90 mm Petri dishes and a 400 hole hard-anodised aluminium sampling head, avoiding the expense of proprietary sampling media. Using standard readily available consumables, at low cost with a variety of media, makes the MicroBio MB2-HiFlow an economical instrument to use. In use worldwide, the MicroBio MB2-HiFlow bioaerosol sampler is an invaluable device to help meet a wide range of compliance standards.

Supplied with the MB2-HiFlow Bioaerosol Sampler

  • 400 x 1.0 mm hard-anodised aluminium sampling head

  • Operating manual

  • Hard back padded carry case

  • Mini table-top tripod

  • Multi-voltage worldwide charger with UK, Euro, USA, Australia and 12V in-car plugs and pre-charged cells so the MB2-HiFlow is ready to use out of the box

  • Optional medical grade mains power supply

  • Certificate of Calibration
     

 

 

 

 

 

 

 

 

 

Downloads

MicroBio MB2 and MB2-HiFlow Manual

Positive Hole Correction Analysis Spreadsheet using Excel™ (Windows™ or Libre Office)

Positive Hole Correction Analysis Spreadsheet using Numbers™ (Apple Mac)


Tripod  (Part No. P0001TRI001) – INCLUDED AS STANDARD

Aluminium indoor table-top tripod for use with MicroBio MB2-HiFlow. This tripod enables the MB2-HiFlow to stand on its own with a height range of 145 to 245 mm (to base of MB2-HiFlow).

 

 

 

 

 

Replacement Parts

Head Retaining Spring  (Part No. P0001M009)

Replacement sampling head retaining spring.  Sold individually

 

Contact Plate Holding Springs (Part No. P0001M007)

Replacement springs used to hold 55 mm contact plates.
Sold in a pack of 3.

 

Petri Dish Retaining Springs (Part No. P0001M008)

Replacement springs used to hold 90 mm Petri dish plates
Sold in a pack of 3.

 

Spring Retaining Screws  (Part No. P0001SCR003)

Replacement stainless steel M3 x 6 screws used to fasten the dish, plate and head retaining springs.  Sold in a pack of 10.